Citation and commencement

1. These Regulations may be cited as the Violent Crime Reduction Act 2006 (Specification for Imitation Firearms) Regulations 2011, and shall come into force on 11th August 2011.

Interpretation

2. In these Regulations—

“the 2006 Act” means the Violent Crime Reduction Act 2006;

“blank-firing imitation firearm” means an imitation firearm capable of firing a blank cartridge;

“inclusion” means part of an imitation firearm incorporated into the firearm during manufacture for the purpose of preventing an imitation firearm being modified for use as a firearm;

“revolver” means a firearm that has a cylinder (containing multiple chambers) that revolves to align each chamber in turn with the firing mechanism and the barrel.

Specifications for imitation firearms

3. —(1)Blank-firing imitation firearms, other than those described in paragraph (2), shall conform to the specifications set out in regulation 4.

(2) The blank-firing imitation firearms described in this paragraph are—

(a) imitation revolvers; and

(b) imitation firearms where the blank cartridges are loaded vertically at 90 degrees to the dummy barrel and which fire, and vent the gases produced on discharge, in the same direction.

4. The specifications referred to in regulation 3(1) are that—

(a) an imitation firearm must incorporate an inclusion;

(b) the inclusion must be wholly made of a material which is at least as resistant to being cut, drilled, bored, ground (or any similar process) as sintered tungsten carbide in the range 1550-2000 HV 30( 2 );

(c) the inclusion must wholly block the barrel and should be permanent and incapable of being knocked out without destroying the chamber or barrel;

(d) part of the inclusion must be incorporated into the rear of the dummy barrel; and

(e) the inclusion must be intended to prevent—

(i) the creation of a hole through the dummy barrel along its axis; and

(ii) the removal of a dummy barrel, unless the frame and chamber area of the firearm is rendered useless as a result or its integrity so compromised that it cannot be used to form the basis of a firearm without significant repair or addition.

5. Blank-firing imitation revolvers shall conform to the specifications set out in regulation 6.

6. The specifications referred to in Regulation 5 are that—

(a) an imitation revolver must incorporate an inclusion cast into the dummy barrel and a separate inclusion cast into the cylinder which extends to fully obstruct all the dummy chambers;

(b) the inclusions must be wholly made of a material which is at least as resistant to being cut, drilled, bored, ground (or any similar process) as sintered tungsten carbide in the range 1550-2000 HV 30;

(c) the inclusions should be permanent and incapable of being knocked out without destroying the chamber or barrel;

(d) the barrel inclusion must wholly block the dummy barrel and part of it must be incorporated into the rear of the dummy barrel;

(e) the barrel inclusion must be intended to prevent removal of the dummy barrel, unless the frame of the firearm is rendered useless as a result or its integrity so compromised that it cannot be used to form the basis of a firearm without significant repair or addition;

(f) the inclusions must be intended to prevent the creation of a hole through the dummy barrel or chamber along their axis; and

(g) the revolver must vent the gasses produced on discharge at not less than 80 degrees from the axis of the dummy barrel.

Exemptions

7. The offence in section 39(2)(d) of the 2006 Act (bringing into Great Britain an imitation firearm which does not conform to the specifications) shall not apply to persons whose conduct in bringing into Great Britain an imitation firearm, or causing an imitation firearm to be brought into Great Britain, was for the purpose only of making the imitation firearm in question available for one or more of the purposes set out in section 37(2) of the 2006 Act.