Citation and commencement

1. These Regulations may be cited as the Road Vehicles (Construction and Use) (Amendment) Regulations 2017 and come into force on 20th May 2018.

Amendment of the Road Vehicles (Construction and Use) Regulations 1986

2.The Road Vehicles (Construction and Use) Regulations 1986( 2 ) are amended as follows.

3. In regulation 18—

(a) in Table I in paragraph (3)—

(i) after item 3 insert—

(ii) in item 4 for “1 to 3” substitute “1 to 3A”,

(b) after paragraph (3) insert—

“ (3A) For a category T tractor which is driven at more than 40 km/h, when drawing an agricultural trailer each component of the combination shall comply with the requirements of that component specified in item 3A(a) of Table I and with paragraph (5)(c). ” .

4. Omit regulation 18A.

5. In regulation 70(1) omit “goods”.

6. After regulation 110 insert—

“ Review

111. —(1) The Secretary of State must from time to time—

(a) carry out a review of the regulatory provision contained in—

(i) regulation 18 in so far as it relates to the efficiency of brakes,

(ii) regulation 70,

(iii) paragraph 8 of Schedule 7B, and

(b) publish a report setting out the conclusions of the review.

(2) The first report must be published before 20th May 2023.

(3) Subsequent reports must be published at intervals not exceeding 5 years.

(4)Section 30(3) of the Small Business, Enterprise and Employment Act 2015 ( 3 ) requires that a review carried out under this regulation must, so far as is reasonable, have regard to how Directive 2014/45/EU of the European Parliament and of the Council of 3 April 2014 on periodic roadworthiness tests for motor vehicles and their trailers is implemented in other member States.

(5)Section 30(4) of the Small Business, Enterprise and Employment Act 2015 requires that a report published under this regulation must, in particular—

(a) set out the objectives intended to be achieved by the regulatory provision referred to in paragraph (1)(a),

(b) assess the extent to which those objectives are achieved,

(c) assess whether those objectives remain appropriate, and

(d) if those objectives remain appropriate, assess the extent to which they could be achieved in another way which involves less onerous regulatory provision.

(6) In this regulation, “regulatory provision” has the same meaning as in sections 28 to 32 of the Small Business, Enterprise and Employment Act 2015 (see section 32 of that Act). ” .

7. In Table I in Schedule 2—

(a) omit item 74C,

(b) omit item 83,

(c) after item 94 insert—

8. In paragraph 8 of Part II of Schedule 7B—

(a) in sub-paragraph (1)(a) at the end insert “, or the manufacturer’s plate value if lower”,

(b) in sub-paragraph (1)(b) at the end insert “, or the manufacturer’s plate value if lower”,

(c) in sub-paragraph (1)(c) after “July 2008” insert “but before 1st January 2014, the manufacturer’s plate value if available, otherwise”,

(d) after sub-paragraph (1)(c) insert—

“ (d) if the vehicle is first used on or after 1st January 2014, the manufacturer’s plate value if available, otherwise 0.7 per metre ” ,

(e) for sub-paragraphs (2)(a) and (b) substitute—

“ (a) point 8.2.2 of Annex 1 of Directive 2014/45/EU ; or

(b) point 8.2.2 of Annex 2 of Directive 2014/47/EU ” .